Unified inch · UNC
3/4-10 UNC tap drill size
For general work, OSG suggests 65–70% of full thread. Harder materials and deep holes want less; the calculator sets it from your material.
Cut tap
21/32
0.6563" · 72% thread
Form tap
45/64
0.7031" · 69% thread
Pick your material for its % of thread, tapping RPM and the rigid-tap code.
Thread dimensions
- Major Ø
- 0.7500" (19.050 mm)
- Threads per inch
- 10 (pitch 0.1000")
- Pitch Ø (basic)
- 0.6850" (17.400 mm)
- Minor Ø (internal, basic)
- 0.6417" (16.300 mm)
- Thread depth (internal)
- 0.0541" (1.375 mm)
Basic sizes of the 60° form. Tolerance classes (2B/3B) set the limits around them.
Cut tap drills
For a cutting (fluted or spiral) tap. Every standard drill from 50% to 85% thread; suggested rows are in the 65–70% band.
| Drill | Ø in | Ø mm | Thread |
|---|---|---|---|
| 41/64 | 0.6406 | 16.27 | 84% |
| 16.5 mm | 0.6496 | 16.50 | 77% |
| 21/32 | 0.6563 | 16.67 | 72% |
| 17 mm | 0.6693 | 17.00 | 62% |
| 43/64 | 0.6719 | 17.07 | 60% |
Form tap drills
A form (roll) tap displaces metal instead of cutting it, so it needs a bigger hole. Every standard drill from 50% to 85% thread; suggested rows are in the 65–70% band.
| Drill | Ø in | Ø mm | Thread |
|---|---|---|---|
| 45/64suggested | 0.7031 | 17.86 | 69% |
| 18 mm | 0.7087 | 18.00 | 61% |
3-wire measurement
- Best wire size
- 0.0577" (1.466 mm)
- Over wires, at basic pitch Ø
- 0.7717" (19.600 mm)
For the external thread (the screw). The best wire touches the flanks at the pitch diameter.
Sources
- ASME B1.1 — Unified Inch Screw Threads (UN and UNR thread form)
- OSG — Tap drill size and pitch diameter limit chart (formula, suggested % of full thread)
- Cutting Tool Engineering — "Threads will roll": form tap hole size = D − 0.0068 × % / TPI
- ASME B94.11M — Twist drills (fractional, number, letter and metric sizes)
- NIST (NBS) Letter Circular 23 and Pratt & Whitney — three-wire thread measurement, best wire size